What exactly is the difference between a surge protector and a fuse? Can a fuse protect the electronic devices from lightning instead of surge protector?
12.06.2025 00:43

Would individual surge supressors have save this equipment? most likely, since the surge supressor would take the jolt instead of the electronic components.
2024–10–16 [ OO OLAOYE OYEBODE ]
For this case there are devices called Metal oxide varistors (MOV).
Which movies have the best endings?
I post the exact comment here.
but this device (an Inductor) … impedes the rapid changes in the current.
He then asserts :
The #1 Dessert to Help Lower Dementia Risk, According to Dietitians - EatingWell
(There is no concept of polarity, in the loop because the current changes direction 100 to 120 times a second (power frequency).
This is the picture of an electronic coil of wire wound around a core of magnetic material.
But during the surge, the fuse will not blow if it is a longer duration and lower value )10 to 50%).
Moving sucks, but decluttering helps - The Verge
At one ohm, the resistor has a maximum of 1 watt power.
So combined with a device called a MOV or Metal-oxide-resistor, then forms the 3rd part of a “surge suppressor “.
The bolt then partially travels down the line to your home.
James Bond game 007 First Light gets first trailer - The Verge
This is an electronic circuit designed to clamp voltages so that the Voltage Potential that appears at the outlet is never going to exceed the nominal value.
so, the loop of wire then, when put together with another loop reduces the ‘noise’ on a power line.
2024–10–11 [Bobby Sanchez Bobby Sanchez ].
Why Passing on Palantir Technologies Stock (PLTR) is a Big Mistake - Yahoo Finance
What does a fuse do?
The MOV will conduct when the voltage exceeds 50% of line voltage.
Here is a simplified AC power diagram.
M’s Kirby struck in face by 103 mph line drive - Seattle Sports
The third is lightning and “how it gets conducted into a home.”
Upvotes:
a photo is worth a thousand words.
How do you feel about the impending end of what Donald Trump calls "the Green New scam"?
These devices are installed between the “hot” and “neutral” and protective ground.
Mohan forgets that a fuse is a one-time device, and needs to be replaced if it is tripped.
“ … to protect building, lightning arrestor, is provided above building and directly connected to earth.”
Reports: Bills RB James Cook ‘won’t be in Buffalo anytime soon’ - Buffalo Rumblings
First Sentence:
(Dc diagram shown, AC is similar).
He then describes Rainy Season and Lightning.
But it can get overloaded, and no longer works.
These are simplified answers to the original question, and does not change anything I wrote above.
So, it’s possible that these devices from Trip Lite have addition suppression devices, these ones seem to be sturdy.
Do women like men who have slept with many women?
One is “what exactly is in a ‘surge protector’ ? ”
2024–10–14 [Omar Gharbi Omar Gharbi ]
Can the fuse protect the electronic devices from lightning instead of a surge protector.
2024–09–27 [ Mohan Rajaratnam Mohan Rajaratnam ] . Thinks you can get free electricity from nothing : Mohan Rajaratnam's answer to Is it possible to generate free electricity at home using a magnet or other low-cost methods? If so, how does it work?
so, what happens?
There are three different concepts here that are getting confused.
In my experience, British people are fat, ugly and arrogant. Why is it and can it be changed?
It’s been three xxx five werks, and there has been no response to my follow on query on his Commment to my answer.
He then describes the function of a fuse.
If the nominal power is 4,000 watts then the current at 230volts is 16 amps.
the problem then depends on "how fast does the fuse operate?".
A fuse is a non-resetable over current circuit protector.
So, the voltage could go up to 500 volts, and the fuse will not open up.
Knight, Nurse among unprotected in PWHL expansion - theScore.com
This is a photo where a lightning bolt took out a home's complete mains distribution box, and a lot of electronic gear as well.
but I think this circuit , shows a few more pieces.
When the current is 200% of the rated value , it will “go open” (the link metal melts) and protect the device.
One
P = e* I, so since I is 16 amps, then the voltage dropped is 1/16 volt or 0.0650 volts.
Lightning arrestor is a spark-gap device, and can be installed anywhere. What is important, is that the wire is thick enough to withstand the lightning bolt and conduct the energy away from the building.
At the secondary, it is 1000 times less.)turns ratio). If it gets hit with a 100,000 volt bolt of lightning then the voltage arrestors conduct and clamp the voltage down to line voltage, ( but a small amount leaks down the line). This is the problem.
[image of Common-mode choke]
What is lightning?
Once the voltage goes over 0.0650 volts, then this fact can be used to amplify the difference, and turn the circuit breaker off , furthur down the line. Essentially that is what a RCD/GFCI does, it compares the incoming current, to the outgoing current, and if the difference between the two currents is over 5mA, then it trips the circuit breaker.
Barnstars:
“ A fuse is a device which protects the (circuit) against overload and short circuit.”
OK, this is Mohan Rajaratnam’s definition of a Surge suppressor.
This is a high voltage low current spike that comes down the line because of the power poles being struck, and the voltage suppressors activating on the primary side of the transformer.
This one hit behind the barn.
2024–10–10[John johnson John Johnson ]
2024–10–00 [ Ammar Mahdi ] Ammar Mahdi
“ A surge suppressor is the one which is connected at the input supply so that when there is a sudden change voltage it bypasses thereby protecting the (circuit) and electronic components”
The other is “what does a “fuse” do?”
Fuses, on their own, then operate much slower than the MOV variable resistance, during the lightning strike.
Edit 2024–10.
An AC voltage/ current source, and an ac inductive load.
eight
It seems Mohan does not understand the difference between a comment and an Answer.
[old diagram got deleted by accident]
It also is a device that limits the change in current flow.
This is where the MOV conducts again, and dissipated the energy.
At least they know the answer if they wanted it.
This is where this question deviates from being a 'generic' question, and becomes more specific.
There are two important concepts here.
nine
In schematic diagrams this is the symbol for a fuse:
2024–10–11 [Victor Olarewsju Victor Olarewaju ]
Now when you have a certain ac resistance, then a current flows in a loop.
what exactly is a ‘surge’ protector?
This device then solves the entire problem.
A circuit breaker is similar, but is resettable.
And this is the problem alone. Is the power supply in the equipmemt designed with a lightning strike in mind? Some yes, others, no.
Is the question then , "why buy a surge supressor, if the fuse alone protects the electronic circuits from a lightning bolt?".
But… the neutral is now “floating” because of the 1 ohm resistance.
This is 'the assistant's answer'
Because the load is inductive, the current lags the voltage.(by a bit).
There is no harm in having the surge suppressor along with the fuse in the circuit. The fuse will not open up until the current melts the link. This will take time, and in the interim, that jolt will get transmitted into the power supplies.